Burriss Amps Boostiest 2.5 Boost

The Burriss Boostiest is a combination of two totally independent gain pedals in a single enclosure. On the right side(input side) is a fully adjustable clean gain pre-amp. On the left side(output side) is a "TS" flavored overdrive circuit. Both circuits feed from the same power source, a single 9V battery or a standard "boss" style power supply.


Gain: To achieve the most natural overdrive tone, set the gain knob low and the level control high. The most overdrive effect can be achieved with the level set low in combination with higher gain.

Tone: This is a high frequency roll-off control that is used to compensate for the tone changes that occur when the device is engaged.

Level: This is the master volume control for the overdrive circuit.

Output: This is the master volume control for the boostier circuit. It should be used in conjunction with the gain control to adjust the desired girth of the note.

Highs: This control is intended to compensate for the increased bandwidth (brightness) as the gain is increased. Roll this knob back to adjust the stock (bypassed) tone curve.

Input: This is the gain control of the boostier (clean boost) channel. This knob is designed to be a set-it-and-forget-it kind of control. It is NOT an attenuator. It is a bias adjustment that will make a TERRIBLE, SCRATCHY NOISE if adjusted with the circuit on. (DON'T TRIP! this is absolutely normal) All adjustments should be done with the device in bypass mode or off.








www.music-blvd.com