Synthmonger Fuzzmonger MK1

The Fuzzmonger mk1 is an all new voltage controlled cross-over Fuzz
pedal designed to give you an unlimited range of fuzz tones! Fuzz
swells, audio fade ins, percussive sounds and plenty more cool tricks
can be achieved with the switchable on-board envelope generator. If
you're looking for a brand new fuzz sound, this pedal is for you!





Controls


Input - guitar, modular synth, toy, etc. plugs in here.
Output - this goes to your mixer or amplifier.
Fuzz - stereo expression pedal input or mono cv input for the Fuzz (drive). voltage range is 0-10V
Filter - stereo expression pedal input or mono cv input for the filter. voltage range is 0-10V
9-vdc input - center negative 9vdc power adapter input.
Fuzz - Offset control for the Fuzz (drive) section. This is basically a VCA pre-fuzz stages.
Filter - Offset control for the VC state variable filter. The lowpass output is selected. The resonance is at a fixed gain.
Gain - Controls the final output volume. Just before noon
posistion will introduce soft-clipping distortion into the circuit. This
section comes at the end of the entire circuit.
Attack - Controls the length of intitial attack or rise before the enevelope generator peaks and switches to the decay.
Decay - Controls the length of the final decay or fade out of the envelope generator.
true bypass - switch for true-bypass of the input signal. when the
led is lit the effect is in use. when it is not lit the signal is
bypassed.
Envelope - switches the envelope generator on or off. When it is
enabled the Fuzz and Filter knobs control the amount in which the
envelope effect each section. This is triggered by the input source as
indicated by the LED.
note - this product is not battery powered!
9 volt, 2.1 mm, negative tip power jack (not included)








www.music-blvd.com